ASSEMBLY INSTRUCTIONS

 

The assembly operation must be performed only by qualified and specialized personnel.

 

To assemble the bindings must proceed as follows:

- The heel has not provided any longitudinal adjustment to adapt to the boot, then it is necessary for fitting in the boot of the binding only use equipment designed for use as a template for the final assembly of the same binding.

- Consult your owner's manual to locate the Top of the Cross above the markers that indicate the proper location for the boot clamp.

- Place the drilling template to match the track with the indicators on the ski center of the mask.

- Draw on top of the ski tip position using the holes marked with P on the mask.

- Remove the drilling template.

- Consult the user manual of the Cross to check the diameter of the tip to use to make the 4 holes.

- Drill holes using the necessary caution.

- Install the screws to secure the tip.

- Attach the boot to the tip.

- Open the release lever on the heel and put the tips in the hollow of the heel of the boot.

- Place the heel on the ski, making sure to keep you well on flat surface.

- Insert a 6 mm thick. Positioned between the heel of the boot block and top of heel.

- Mark the four holes in the heel on top of the skis.

- Remove the boot and the heel.

- Consult the user manual of the Cross to check the diameter of the tip to use to make the 4 holes.

- Drill holes using the necessary caution.

- Install the screws to secure the heel turning the same at 39 ° to facilitate access to the forum.

- Check that the boot is perfectly centered on the axis of the skis.

 

IMPORTANT: The boots on the market have small differences in distance between the metal studs inserted in the tip, after the installation must then check the operation of the automatic closing mechanism is correct.

The lever should automatically take until you reach the end position after the boot was added.

If the shot is not to be correct because the contact caps with studs toe of the boot is not perfect.

 

 

GUIDE TO USE

 

- Read all the instructions in this manual before installation and use of the bindings.

- Verify and check the proper functioning of the bindings before each use.

- Before attaching the boot in the binding to remove snow, ice and any foreign body from the points of clamping between the boot and the binding and the area beneath the soft tip.

- After its use is recommended to dry thoroughly bindings.

- Should they be worn or malfunctioning parts of the binding, contact your dealer or an authorized anyway. You can also contact the manufacturer directly.

- Do not run any kind of modification or tampering with the bindings without permission from the manufacturer.

- Make sure you understand everything stated in the instructions for 'use.

 

 

 

 

 

Connect with us

Contact:

Phone: +39 348 23.10.724

Fax:     +39 011 38.16.517

Email:   fulvio@phksnow.com

 ELMI srl | via Lose, 7 - 10092 Beinasco (TO) | P.IVA / C.F. 08700060018 | R.E.A. TO-993882 |  Privacy | designed and powered by ideex.it